Confirm the cotton core of Sealing Wax Sticks, the length is 1CM is appropriate. Too long or too short will affect the quality, too long may cause the paint to be blackened and covered with a lot of black spots, too short may not ignite.

After the above steps are confirmed, you can operate. In addition, it is recommended that the space be kept dry and ventilated, the workbench should be covered with newspaper, and the workbench should have a large enough position. That's how you can put your skills to use.

After the wax core is ignited, pay attention to the angle of holding the wax stick. Generally, Sealing Wax Sticks is 30-60 degrees from the horizontal plane. Try not to let the flame go directly to the Sealing Wax Sticks, otherwise the dripping wax will definitely be black. Because some buyers may be impatient and hold the sealing wax sticks vertically, it is easy for the wax liquid to extinguish the flame, and it is also possible for the wax with the flame to drip on the paper, which affects the safety.

Secondly, during the burning process, keep turning the flame paint strip so that it is heated and melted evenly.
In this way, drip wax liquid. The color is pure, and then print your own LOGO. Note that after the seal is closed, if it is difficult to pull it out, do not pull it hard. It's easy to pull out once it cools down.
Finally, the perfect product was born!
Another point to remind everyone is that every time you use Sealing Wax Sticks, after blowing out, be sure to use scissors to cut off the cotton core with ashes. Avoid affecting the next use!